Traditional fluorescent lamp (fluorescent lamp) is a glass tube, phosphor coated on the inside filled with mercury vapor and argon, in which the light source is visible light emitted by the phosphor layer covering the inner surface of the pipe. Ideally, the replacement is offered by our company, LED fluorescent lamp.
Benefits of our LED lamps for fluorescent lamps are:
- high energy efficiency (up to 70% in the whole system),
- by far the greater life,
- zero cost of disposal,
- far less heat (great in refrigeration systems),
- no emergency and energy-intensive ballast (ballast) and the starter,
- light output independent of ambient temperature,
- life independent of the frequency of inclusions / exclusions,
- no stroboscopic phenomenon causing rapid fatigue of the eye,
- ignition at low voltage and low temperature,
- high power factor.
The condition for a long lifetime of LEDs is to meet at least two parameters required by the manufacturer, such as adequate supply system (operating current) and the lowest operating temperature. Our answer to that is, inter alia, innovative Power Light - Patented built by a team of engineers and the aluminum housing (being a time sink), which allows well-drained secreted by the diode temperature.
With such solutions, our lamps, as compared with competing products have a longer lifetime and high luminous flux (about 7.5 lm per LED) with a low power rating, which gives eg the stream 120cm 1800lm Lamp - 16W power consumption.
Remember that no amount, only the quality of LEDs, the system of their power and their working conditions create the perfect LED light source!
Our lamps are made in three standard colors of light: cool white 6000-7000K, warm white 2000-3000K, industrial (daily) of a white 4000-5000K, and any other customer's request including the so-called mix.
The basis for our lamps are LEDs SMD (more efficient and endurance over traditional round DIP LEDs) produced by some of the best producers in the world including Seoul Semiconductor and Edison Opto.
Diffuser lamps are three types of lenses: transparent grooved, transparent transparent and opaque milk (special patented PVC to minimize loss of light output). In addition to the replacement of standard length T5, T8, also offer a light source of any unusual length. Our expanding range of bilateral and LED lighting to be applied mainly in advertising and the fluorescent fixtures with side mount (offset by 90 degrees).
Our offer is also enriched with a wide selection of ready-made luminaires fitted with fluorescent tubes, and adapted to work in the system LED. The basis is a high quality range of waterproof and dustproof (IP65) COSMO1 binding. LED fixtures, due to the lack of need for expensive power systems, are an additional financial benefit when using LED installation.
Latest and also increasingly popular source of light is the LED lighting. This technology recently grows up what can be seen in mounting number of produ...
Fairly fast development of LED technology allowed the introduction of ideal replacements for traditional light bulbs and energy saving. In the market we...
LED tapes are ideal for highlighting all kinds of sur- faces: kitchen furniture, stairs, windows. It is ideal for lighting the applicable ceilings. The possibility of...
LED street lamps is the most comprehensive solu- tion for street lighting. Binding of the highest quality plastic and aluminum is fully integrated with the...
Industrial High Bay Fixtures LED can be installed in place of the existing lamps such as metal-halogen, resulting in immediate electricity savings of up to...
SMILE LED © Copyright 2012. All rights reserved. Project by 